Razor AMG UH-1 Holographic Sight

Description

Razor AMG UH-1 Holographic Sight

Introducing a new paradigm in Holographic Weapon Sights. The UH-1 uses our revolutionary Fusion Hologram with Quantum Well Light Control (FHQ) technology to deliver the first holographic sight to meld the durability and energy efficiency of a red dot with the impressive sight picture, zero-distortion, and reticle pattern of a holographic sight. The scratchproof XR plus fully multi-coated windows and holographic elements are incredibly durable and promote optimal light transmission. All sensitive components are protected in the base of the sight, increasing durability, while eliminating the need for an obstructive secondary shroud.

Integrated Mount – Quickly attaches to any Weaver or Picatinny rail with the integrated mount.

EBR-CQB Reticle

The EBR-CQB is designed to take full advantage of both the center dot and the bottom triangle for targeting.

Use the center dot for zeroing your rifle and as the point of aim for targets at 25 to 400 yards/meters.

The bottom triangle will be your point of impact for close quarters distances of 10 yards/meters or less.

Windage and Elevation Adjustments

Use a coin or other flat head item to turn the knobs to adjust for point of aim. For both adjustment knobs, one click will change the point of aim approximately 1/2 MOA when zeroing. One full rotation of either knob will change the point of aim approximately 16.5 MOA—8.25” at 50 yards or 16.5” at 100 yards when zeroing.

Please note: When adjusting, you may encounter increased resistance. This means the end of the adjustment range has been reached and you should not turn the knob any further.

Integrated Quick Release Mount

1. To open the mount, depress the lock button and swing the quick release mount lever 90 degrees to the open position.

2. Position the UH-1 down onto the rail in desired location and move mount lever back to closed position.

3. Check lever closing tension. Lever should close with moderate pressure using thumb or finger. It should not require excess force to close. If lever won’t close, closes with excess force or seems extremely easy to close with little or no tension, proceed to step 4.

4. To adjust the tension, move the lever back to the open position. Using a flat blade screwdriver or similar device, turn the adjustment nut (pictured) left or right to loosen or tighten (left-looser, right-tighter). Make small adjustments of one or two clicks, then check lever closing tension. It may be necessary to repeat this process a few times until desired tension is achieved. Move lever back to closed position after adjustment is complete.